Want to know what PCB layers stand for ?

Want to know what PCB layers stand for ?

Beitragvon jackwong1931 » Fr 12. Jul 2019, 06:03

A lot of new guys may not know what thePCB layer means or stand for . Now here you go .



t0185559c693ab05099.jpg



1.Top layer


It’s also called components layer , mainly to be repalced parts . For PCB board , then plays a role of layout .





2.Mid layer


Normally speaking , maximum 30 layers inside , mainly place signal line .



3. Bottom layer




Called solder mask layer , mainly to place wiring and weld , sometimes it would also assembly parts on it .

Top overlayer and Bottom overlayer



To remark parts outline , value , position or others you need info .



4. Solder mask layer




Including top mask and bottom mask , the layer of PCB file pad and via hole data is generated by protel PCB ,mainly used for laying solder mask. The board uses a negative output, so the pads and vias shown on the board represent the area on the board where the solder resist is not applied, which is where the solder can be soldered.



pcb assembly cost

5. Paste mask Layer


Including top paste mask and bottom paste mask , it is used to correspond components solder join when it goes through oven , but also negative output . The pad and vias shown on the board represent the area of the board where the solder paste is unprinted, which is where no soldering is possible.



6. Drill Layer


- solder mask or not , means appear copper on the PCB or not

-paste is to make stencil

So when we draw the board , the two layers have to be drawn .
jackwong1931
 
Beiträge: 3
Registriert: Fr 12. Jul 2019, 05:55

Zurück zu Allgemeines / General Information

Wer ist online?

Mitglieder in diesem Forum: 0 Mitglieder und 0 Gäste

cron